Sprite Eco Cork Grips With Plug Shockcord (Set of 2)

YOU WILL RECEIVE 2 GRIPS WITH EACH ORDER.

To replace your Micro Sprite handle grips, first remove the bar ends and then use a sharp knife to cut and remove the old grips. To install the new grips, apply a small amount of lubricant like hairspray or dish soap to the inside of the new grips and the handlebar, then slide the new grips on, and push the bar end back in.

Step 1: Remove the old grips

Remove the bar ends: On models with foam grips, you'll first need to pull out the rubber ball or end cap, and on some, you may need to push a pin through to get the cord loose. On other models, the bar end might just be a push-fit or require a tool to remove, such as a thin cone spanner.

Cut the old grips: Use a craft knife to carefully cut the old foam or rubber grips lengthwise along the groove in the metal handlebar.

Peel off the grips: Once cut, peel the old grips off the handlebar